PTO Gearbox | PTO Pumps | PTO Valves

 

 

The Power Take-Off, most commonly referred to by its acronym, PTO Gearbox Manufacturers, is a common form of mechanical power delivery in the mobile machine market. The PTO Gearbox Suppliers is a method of transferring high power and torque from the engine (usually via the transmission) of trucks and tractors. In combination with gearboxes and pump mounts, nearly any type of mechanical power transmission is possible.

There are three common power take-off methods in the mobile machine market; tractor style, truck transmission style and engine crankshaft-driven, although the latter is not commonly referred to as a PTO Gearbox Manufacturers. The crankshaft-driven method of power transmission is often used for hydraulic pumps mounted to the front of an on-highway truck, such as a plow/spreader or cement mixer PTO Gearbox Suppliers. A small shaft with U-joints attaches to a yoke coupler to turn the pump. This configuration of drive is not generally referred to as a PTO, however.

The Cross series 50T PTO Pumps Manufacturers are designed to be driven by a 540 rpm PTO and provides a 3:1 speed increase for the pump to provide flow for a variety of farm applications: for example front-end loaders, augers and wing fold implements. The thru-type 6 spline internal shaft permits the use of a stub shaft PTO Pumps Suppliers driven accessory which simultaneously drives the pump.

The leading single-stage split-shaft fire PTO Pumps Manufacturers on the market today provides efficient use of power and performance. Designed with a two-piece, horizontally split body with intake and discharge passageways in a single casting and on the same level, this pump provides the lowest possible height, a lower center of gravity, and more room for hose reels, hose beds and other equipment.  The PTO Pumps Suppliers -Driven CS / CSU Series is available with a K-Series, gear-driven transmission designed for use with a side-mounted PTO or a PA Series (PA not available on CSU Series), chain-driven transmission designed for use with an Allison Transmission with 10-bolt PTO.

A new panel/dash mounted PTO Valves from Mead has a safety interlock to prevent accidental engagement of the PTO Valves Manufacturers which can cause severe accidents. This new valve has a re-set port that requires a signal to be removed or applied before the valve may be operated. This re-set signal can be interfaced with the vehicle’s hand brake or an alternate device to assure the PTO Valves Suppliers can’t be operated until the safety interlock is activated. These new valves can activate the re-set function via a remote air signal or with an electrical solenoid integral to the valve.  

PTO Valves Suppliers from RS are suitable for panel/body/dashboard mounting, feature actuation using a push-pull knob, and may operate within temperature limits from -10°C to +50°C. The valves accommodate a maximum flow up to 300 litres per minute, and a pressure range from 0 to 16 bar. Power Take-Off Valves may be used as control valves for power take-off PTO Valves Manufacturers applications on commercial vehicles. Power Take-Off Control Valves feature an integrated handbrake interlock safety function (to prevent, for example, a vehicle being driven while the Power Take-Off is still engaged). The valves may also be used within general industry applications as a push-pull control valve.